528 issued permits in Sunset/Parkside, part of San Francisco, California. Refreshed every 6 hours from the city's public permit feed.
528 permits
installation of level 2 evcs, 9 tesla universal wall connector 48a ev chargers ("evse") to be assigned to staff/ resident ev drivers in assigned parking areas.
lower floor - add 2 bedrooms, 2 full bathrooms, family room & kitchenette with 2 burners
1/f: enclose & remodel entry and staircase, add 1/2 bath. 2/f: remodel kitchen and relocate interior stair, relocate 1-bath, add 1-pantry, add 1-office. 3/f: relocate interior stai…
revision to pa #202507231418 to add new footing detail at location of existing share footing. detail 9/s4
spcb report# 260120a147 dated 1/20/26 - item# 1 only replace rear window and door trim boards of like kind. not visible from street.
reroof. no hotworks
to obtain final inspection for work approved under pa#202104168722.
kitchen remodel in-kind remove a portion of the wall seperating kitchen and dining. wall removed is approximately 1'-6"
bathroom located on second floor remodel to include remove bathroom and sink and adding vanity. adding (n) exhaust fan with (n) opening. no wall removal.
reroof: tear off (e) shingles. install new shingles. no hot works.
re-roofing: remove and replace roofing material / existing roofing material (in-kind)
kitchen remodel like for like. in kind, approx 80 sq ft.
re-roofing with torch down
revision on permit pa #202512172021: to relocate existing internal stair from 2nd floor to ground floor. to remove ground floor kitchenette and add only wet bar and cabinets.
remodel 1 kitchen and 2 bathrooms like for like, replace ceiling insulation in kitchen and living room.
replace front of building stucco and repair 1/2 inch plywood underneath if needed. dining room will get new baseboard and new electrical; lights and plugs will be installed to code…
to obtain final inspection for work approved under pa #2024-0410-9722. all work is complete.
re-roofing no torch down.
re-roofing: tear off old roof surface, apply 1 layer 28lb base felt down, apply 1 layer of sta torch down, apply 1 layer of gta torch down